centrifugal spinning concrete pipe making machine is a kind of machine to produce concrete pipes and Pre-stress concrete pipe.It can make pipes with diameter from 300-2500mm and with length from 2000-5000mm. We can design many kinds of pipe joint, including flush joint(flat mouth type), groove joint, socket and spigot joint(socket and plug mouth type) ect. And all the concrete pipes are widely used in administrate drainage, agricultural field irrigation, rood culvert and deep water well .
1 Short production Cycle: because of the good effect of the roller to compact the concrete, every pipe just need 1-10 minutes with high speed roller rotation.
2 This Pipe machine use the dry cast material, there will no waste cement mud, then it wont pollute the environment.
3 During the production, the noise is low, it is about 80-90 DB
4 The Concrete Pipes are with high pressure load and with high production efficiency.
centrifugal spinning concrete pipe making machine use the Roller to support the pipe mould, and produce the roller force to concrete in the mould. When the roller rotate at a high speed, the concrete in the mould will spread in the inner wall of the pipe mould and form a cement pipe with the centrifugal force, and when the mould with the inner concrete pass on the roller,the concrete between the mould and the roller will be compacted solid to form a pipe.
Email: pony@concretepipemachines.com
Mobi: +86-15192160306
No comments:
Post a Comment